[misohorny]

I won't be able to flash the new firmware for a few months while I holiday in Europe but I'm dying to know if the interlaced Pal resolution has been fixed. Could someone put me out of my misery?

 

[vjren]

If you want [email protected], it still is reported by my projector as 60Hz, so it seems to be still not fixed..


Does it give jerky playback with you too if used at 60Hz? It's either the pal 60Hz that just doesn't fit or my projector can't keep up at pans.. It looks ugly..

 

[misohorny]

Vjen,

Thanks for the reply, I'd given up hope of a response.


Fortunately I have a CRT projector (Sony 1272qm) which can display almost any analog signal.

Before the custom resolution firmware, I tested Pal 720p and 1080i, at 60Hz. Both were jerky but 1080i was the worst of the two. It's not your projectors fault.

Now, I use a custom 720p @50Hz, which is great, but I like the idea of reducing the stress on the projector by using 1080i @50Hz.


You'd think the brains at Momitsu would pull their finger out.



Cheers,


Miso


P.S. Van Dieman was a dutch explorer wasn't he?

 

[vjren]

I am sure they will fix the PAL support.


But in the mean time, do you care to give me your settings? I'd like to try the [email protected]


There have been a lot of dutch explorers, i'd have to look this one up

 

[vjren]

The custom settings work only on DVI? I need them on VGA (over DVI-A) or component!

 

[mack.nl]

@ vjren here two of my settings to try (used for sanyo z2


38450 5000

1250 0720

1528 0064

0048 0136

0769 0011

0016 0022


37800 5000

1280 0720

1664 0064

0192 0128

0756 0006

0018 0012


the last one gives the best result for me


GR


mack

 

[vjren]

Right, but only on DVI right?


I mean if you switch to YUV Component, do you get the same picture?

 

[mack.nl]

you can try dvi-a its a rgb output if your projector can use rgb

as for i no custom settings only on the digital output

 

[misohorny]

Vjren,

The Momitsu V880 outputs analog (VGA) through its DVI-I connector, all you need is a cheap DVI-I to VGA adapter (about $10).


The custom settings set the VGA output - thats the only way I use the Momitsu.


EmuMannen made available a neat little program for calculating custom resolutions called
CR4V880 , and that's what I used to generate the [email protected] numbers.



29650 5000

0720 0576

0896 0016

0072 0088

0593 0001

0003 0013

0000 0000


I hope this helps you get a jerk free 720p


Cheers,

 

[vjren]

That is what i wanted to try this evening, I already had a vga-dvi adapter.

I connected and them wham remote not working anymore as in my new thread, I unpowered and will let it rest a day see what it does then..


Thanks so far, it WAS great the V880, but this I don't need