AVS Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
92 Posts
Discussion Starter #1
I have the monoprice 4x2 switcher seen here: http://www.monoprice.com/products/product.asp?c_id=101&cp_id=10110&cs_id=1011002&p_id=5312&seq=1&format=2


I have a Buffalo wired IR extender running over Cat5 from which I am able to control the other devices in this location. I am however, unable to control the monoprice switch. If I use the remote directly I can control the switch. I see on the receiving side of the IR extender, the LED indicating it is receiving the signal. However, the switch doesn't seem to respond.


Has anyone used an IR extender with these switches or have any troubleshooting suggestions?
 

·
Registered
Joined
·
1,106 Posts
1 - 2 of 2 Posts
Top