AVS Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

· Registered
Joined
·
15 Posts
Discussion Starter · #1 ·
I have just installed a new power supply board in my Barco Data 800.


I plugged the unit in and nothing popped or blew up... thank goodness!


Now, the unit seems to be in stand by mode, which is indicated by the red LED on the back of the unit that says standby.


I pressed the standby button on the remote and nothing happened. Well, the RCU LED did light up on the black control panel.


I have 2 LEDs on the control board lit... one is the Standby LED, which is constantly on and the other is the Processor Cycles LED which is blinking very rapidly.


THe power switch seems to do nothing. The standby LED on the back of the unit is on regardless of the on/off switch...


Any help would be appreciated.


Scott
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top