AVS Forum banner
Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
251 Posts
Discussion Starter · #1 ·

·
Registered
Joined
·
5,132 Posts
There must be a midget in your PJ as his finger/arm is in the way :D


Just kidding, it appears like dust blob on the DLP panel which should focus away from the actual image. Try to blow with air from a large syringe (becareful of liquid compressed air as may spew liquids on your panel which will be tough to clean) or hand pump (used for blowing up long balloons to make animals).
 

·
Registered
Joined
·
251 Posts
Discussion Starter · #4 ·
I got my projector back on Wed. it turned out to be a small piece of lent. Toshiba fully cleaned the projector and upgraded the firmware to 2.2, works and looks like new again.


Mike
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top