AVS Forum banner
Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
65 Posts
Discussion Starter · #1 ·
v1.60 release of MyHD comes with a resolution of 1280x768. I would have thought that was tailored for the Pioneer 503CMX native resolution. But when I selected that resolution, I got significant overscan on left and right edge and black bar on top and bottom. If I switch to 1280x720, it seems to work fine.

My question is can the MyHD output timing be adjusted? or is there someway to adjust the 503 to accommodate the 1280x768 native resolution.

What does MyHD + 503 users used in their setup?
 

·
Registered
Joined
·
65 Posts
Discussion Starter · #2 ·
I tried to call Digital Connection (where I got my card from) and I got the reply "post your question to the MIT website". :(
 

·
Registered
Joined
·
13,423 Posts
Did you post your question over in the plasma forum where you can find users that actually know how to use the PDP503CMX?


Also in the Aspect Ratio/ A/V Settings section of the User Manual you will find the instructions on how to turn off the "Auto Mode" and will allow you the option of several settings to fit an image to your screen.
 

·
Registered
Joined
·
65 Posts
Discussion Starter · #4 ·
I did posted to the plasma forum with no response so far.


I will give your suggestion a try. Thanks Cliff.
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top