AVS Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
1,420 Posts
Discussion Starter · #1 ·
Has anyone succesfully used the NEC control software to setup there projector I am moving into a new house and downloaded my settings on my 6pg xtra before I took the PJ down will I be able to just re hang it and up load my previous setting from my computer to get the convergence back in line or will I have to get it recalibrated again which might not be that easy to do.




Thanks
 

·
Registered
Joined
·
5,313 Posts
It is highly unlikely that your geometry and convergence will match your current setup, unless the projector winds up with 1/4" or so of it's exact position to the screen in your current setup.


Your other settings, such as black and white levels, color balance etc should be fine.


A minor touch up of geometry and convergence should not require a full ISF setup.


It's still a good idea to save all the settings with your PC program in case you ever have to reset your EPROM, but the projector should also remember them.


Vern
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top