AVS Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
1,476 Posts
Discussion Starter · #1 ·
I've attached two pictures where our home theater will be built.


First one:
http://bucklemke.com/images/picture-017.jpg


Close up:
http://bucklemke.com/images/picture-018.jpg


The wall above is where my screen will go (4:3 120" diagonal). The beam that runs across the ceiling is about 10' from the wall. I'm assuming that I can remove the iron support, and replace it with two of them off to the sides a bit, so that it won't be in the way. I'm planning on getting an NEC HT1000. Will this beam cause any problems? According to this page in order to get a 120" diagonal with this projector I'd need to mount it 12-15 feet from the screen. If I have to mount it a couple feet below the ceiling because of the beam in front of it, will this cause any problems? Any thing else I should be aware of?
 

·
Registered
Joined
·
1,182 Posts
Here's a link to the HT1000 installation manual:

http://www.necvisualsystems.com/corp...1000IG_v15.pdf


As you'll see, the HT1000 acually mounts quite a bit higher than the screen. I can really visualize what that's going to do in your setup, but there could be problems.


MIKE
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top