AVS Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
119 Posts
Discussion Starter · #1 ·
I just picked the unit up off of ebay! Does anyone have any idea what this code means. I hope it's not like my projector (9pg) when it's flashing an error code. THat means I have to spean money to replace a board.
 

·
Registered
Joined
·
6 Posts
Hi,


be cool. :D You can use the switcher as standalone or coupled with your projector with an Terminal Cable. If you use the Switcher standalone, pull the System Controlboard left between the Powersupply, and set all Switches from s601 to closed. If you use the Switcher with your Projector, you must switch dip 8 from s601 to open. The Terminalcable you need, has two male mini D-sub 15pin connectors. The Connection is following:


1 ---> 1

2 ---> 2

6 ---> 6

7 ---> 7

9 ---> 9

15---> 15


This is the pinout, you need.


Good Luck,


Joerg


:)
 

·
Registered
Joined
·
4,916 Posts
The 20 just means that the switcher is set up for the "connected" mode. In which case you can run the cable as Joerg has suggested, or go in and set up the switcher for the standalone mode.


Terry
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top