[JPG35s]

Hope this is the right section.


I am getting ready to purchase a Klipsch RC-52 center and I want to mount

it on the wall using a shelf above my flatscreen that I have on a stand .


RC-52 measurments show to be 20in-w X 10.5in-d. The shelf i am going to buy is 24in-w X 10in-d. So the width will work for the RC-52 and since the speaker measures 10.5in deep and the shelf is only 10in-d will my adjustable legs that are on the bottom of the RC-52 be hanging off the shelf in the front or back?

If anyone can help me as to where the legs are positioned on the bottom of this center that would help.

Hopefully they are inset about one inch or so that way it will sit on the shelf perfectly.


Thanks in advance.

 

[Ron Alcasid]

I had the RC-51 so I'm not sure if my experience is applicable but it came with rubber bumpers you stuck on yourself. It also came with one foot attached to a long screw. There were threaded inserts in the front and rear bottom of the cabinet where you could screw it into tilt the speaker up or down.

 

[JPG35s]



Quote:
Originally Posted by Ron Alcasid /forum/post/18167254


I had the RC-51 so I'm not sure if my experience is applicable but it came with rubber bumpers you stuck on yourself. It also came with one foot attached to a long screw. There were threaded inserts in the front and rear bottom of the cabinet where you could screw it into tilt the speaker up or down.

thanks.