AVS Forum banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
273 Posts
Discussion Starter · #1 ·
Just got my new Krell Showcase preamp, and I can't get the OSD to come on. I connected my HDVR2 tivo to the S-Video1 input on SHowcase, and then connected another S-video cable to OSD S-Video out and to the TV. I get no signal... some video noise appears for a few seconds, then blank again. When I connect S-Video out to the other one (without OSD), I get video fine. Same thing on composite video out. What can be the problem? Please help! I can't setup my preamp without OSD menus!



Thanks


Tony
 

·
Registered
Joined
·
7,335 Posts
Tony,


I don't recall off the top of my head which one it was, cycle through the inputs one at a time --- there's a specific input set to do the initial OSD setup. Once you get the right input selected you should be all set.


Regards,
 

·
Registered
Joined
·
273 Posts
Discussion Starter · #3 ·
Just unplugged power cord and restarted the processor, and everything works... Weird...
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top