Alright, did this once before, but it looks like a recent update changed my settings and I now have to input them again.
I have a Config 0 - set to output at 1080p24sf
I have a Config 1 - set to output at 1080i60
What I want to do is to link each to its own memory so that I can switch between the two on the remote. I would like to make sure that these are the outputs, regardless of the inputs.
I am only using HDMI 1 as the input to the Radiance as my switching is elsewhere and outputting to the Radiance on input 1.
So, in the end, I would like to have it so that:
MEMA - Always outputs at 1080p24sf
MEMB - Always outputs at 1080i60
(regardless of what the signal format is being input)
Any assistance with a bit of a walkthrough?
(I am sure I could figure this out again, but last time it took me a week of playing around).
Thanks
I have a Config 0 - set to output at 1080p24sf
I have a Config 1 - set to output at 1080i60
What I want to do is to link each to its own memory so that I can switch between the two on the remote. I would like to make sure that these are the outputs, regardless of the inputs.
I am only using HDMI 1 as the input to the Radiance as my switching is elsewhere and outputting to the Radiance on input 1.
So, in the end, I would like to have it so that:
MEMA - Always outputs at 1080p24sf
MEMB - Always outputs at 1080i60
(regardless of what the signal format is being input)
Any assistance with a bit of a walkthrough?
(I am sure I could figure this out again, but last time it took me a week of playing around).
Thanks