AVS Forum banner
1 - 13 of 13 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
Hello Guys.
I have installed Rew and got Dayton Audio UMM-6 Usb Mic.
I read few threads but got confused with so much data.

I took a measurement of 6.5" driver, But have problem with phase. Kindly guide as what went wrong and how to take proper measurements.

It seems rar files are not uploaded here-what to do.

Thanks
Vikram
 

·
Registered
Joined
·
13,491 Posts
If you haven't seen it, download and read the REW guide linked in my sig.

After that, if you still have questions, come on back. :)
 

·
Registered
Joined
·
8 Posts
Discussion Starter · #3 ·
I have followed the guide properly and have made all the settings correctly. It was fairly simple.
I also successfully took a measurement. there is some problem with the result. Only if you guys could check the file and guide me as what went wrong.
Measurement room size L10' x W10' x H-9'.

Mic placed 39" from Baffle.
 

·
Registered
Joined
·
13,491 Posts
Post the file and we would be glad to offer some advice.
 

·
Registered
Joined
·
13,491 Posts
Sorry, but I'm not downloading a .rar file. Just upload the .mdat file.
 

·
Registered
Joined
·
13,491 Posts
OK, got it downloaded.

I'm not familiar with the nearfield measurement of individual drivers...but it looks like a good measurement to me. :)

What is it you're trying to accomplish?

 

Attachments

·
Registered
Joined
·
8 Posts
Discussion Starter · #12 ·
I am trying to do a MTM 2 way Speakers.Fb-40Hz. These were measured mounted on enclosures.

One of my DIY designer friends said that phase is not coming correct, So there should me some problem in measurement.
Also if you could check the waterfall and decay plots.
 

·
Registered
Joined
·
13,491 Posts
This is way beyond the scope of my limited REW knowledge. :)

Have you tried posting in the REW thread or the DIY section of the forum?
 
1 - 13 of 13 Posts
Top