I recently bought the spacer system (1 remote, 1 IR dimmer, 1 accessory dimmer), and tried to instal it today. I have relatively little experience with electrical wiring, but this didn't look too difficult since I was only replacing existing mechanical switches.
I followed the directions closely, but after I put everything back together and turned the power back on to the circuit, neither switch works.
How does one go about troubleshooting problems of this type? Can the problem be that the switches themselves are bad?
Any suggestions are appreciated.
Dave
I followed the directions closely, but after I put everything back together and turned the power back on to the circuit, neither switch works.
How does one go about troubleshooting problems of this type? Can the problem be that the switches themselves are bad?
Any suggestions are appreciated.
Dave