AVS Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·



OK, I know this is an old receiver, but it sounds pretty good, works well except for one thing - I cannot get the back speakers setup at all. I mean, the display says no speakers present, hence no 7.1. Auto setup always stops after the last surround speaker (the right one), gives me a phase error (no error, swapped polarity and even tried different speaker and wire), then sets it up 3/2/0, not 3/4/1 like the manual states. Frustrating. Any help would be appreciated. Thanks in advance. This is my first post, so I hope someone has figured this one out. I have an old chevelle I have restored and found the folks at chevelles.com a priceless resource. I'm sure it's the same here.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top