AVS Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
Just purchased Blu Ray Player (Sony BPDS-185/BX18) and plugged HDMI out to receiver ( Yamaha HTR5990) and have to use component to my projector which requires over 30ft so I use RGB but I do not get video . So , I ran the composite to my receiver from the Blu Ray and now I get both sound and video but picture isnt good.. I want both so should I run an HDMI cable from the Blu ray to the Yamaha in and a 35FT HDMI out to the projector ? Will I then get video from the projector and sound from my receiver? Or is there a better solution? Like , I could move the Blu ray closer to the projector and run a 6ft HDMI cable to the projector and then the 35ft RCA cables out of the projector to the HTR 5990 . Would that be the best ? Or?
 

·
Super Moderator
Joined
·
16,693 Posts

·
Registered
Joined
·
1,857 Posts
Not much good posting in a player thread: it is a receiver issue. Nothing to do with analog sunset either if player does not have component video output.


Receivers do NOT output component video from HDMI input. If projector has HDMI then use HDMI out from receiver. That's how most people do it.
 
1 - 3 of 3 Posts
Top