AVS Forum banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
22 Posts
Discussion Starter · #1 ·
After a reboot due to a screen freeze, I am no longer getting video sync. All connections have been checked. I can watch progrma already recorded, but can't record because of no video input. I rechecked and reselected the video input settings, also tried a reboot and reset of the Replay 3030 and even had it call in and redownload the schedules with no success. Does any one have any suggestions?
 

·
Registered
Joined
·
4,612 Posts
I assume you are confident your input signal is of sufficient strength for replay to latch on to it. Here is what I suggest.


1- Shut down, wait 30 seconds and unplug it. Boot it back up. If still no good go to 2.


2- Change all inputs to none and allow replay to call in and configure them. Now go back and put the correct data in and allow replay to call in. If still no good go to 3


3- 777 zones "restore factory default". You will lose all shows but it should fix it.
 

·
Registered
Joined
·
22 Posts
Discussion Starter · #3 ·
Mike

Had to reset, but was able to get AV sync back. Thanks for the tips
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top