AVS Forum banner
Status
Not open for further replies.
1 - 4 of 4 Posts

· Registered
Joined
·
56 Posts
Discussion Starter · #1 ·
my Barco 700 series CRT expects component w/sync


My source is a progressive scan Toshiba sd-9100.


What do I need to just generate the extra sync signal ?


confused here.


craig.
 

· Registered
Joined
·
1,703 Posts
Normally with component video the sync. is combined with the Y. Did you already try feeding in component video ignoring the expectation of separate sync.? Some projectors with a separate sync. input may still accept sync. via the Y.


If that did not work you might try using a Y-connector and sending the Y feed to both the Y input and the sync. input. If the sync. input ignores the positive going content (the video) it will pick up just the sync. and it may work OK.


Video hints:
http://members.aol.com/ajaynejr/video.htm
 

· Premium Member
Joined
·
8,104 Posts
very odd. Are you sure it's not a prep for RGBS ?


Some devices have an optional sync input. If they see something there, they will assume the signal is RGBS, if they don't - they'll assume component.
 

· Registered
Joined
·
3,212 Posts
fwiw, my barco 600 had a toggle, so it would synch on green; but it still had to have rgb; you must have an add-on board if it will even take component.
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top