AVS Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
I just bought an Onkyo TX-NR609 AVR, and the listening modes on the menus do not match those in the manual. In particular, there is no multichannel mode so I do not seem to get bass management for my blu-ray player. I also do not seem to be able to get straight bass management in Dolby D from my TV, as the subwoofer light does not come on. I do have a bass management choice if I'm willing to stick to stereo, but that loses the surround channels.


In the speaker section, I have able to set the cutoff frequencies for the speakers, but there is no separate LFE section in the menus that I can find.


Am I missing a firmware update?
 

·
Premium Member
Joined
·
93,361 Posts
Have your run the AUTO SETUP program (Audyssey)? You also may want to reset the microprocessor (see directions in Owner's manual) to ensure all settings are returned to their factory defaults, although do so before running the AUTO SETUP.


Also note, you would be better served posting in the Onkyo 609 Owner's thread.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top