AVS Forum banner
1 - 3 of 3 Posts

·
Premium Member
Joined
·
47 Posts
Discussion Starter · #1 ·
Have not been able to get any sound from the front (B) speakers for zone 2. Have read the manual and have done all the things it says to do, but no luck so far. Hope I'm just missing some small click. Thanks.

Catbird
 

·
Registered
Joined
·
2,158 Posts
Are you using just 5.1 in the main room. You can only use 5.1 if you wanna use the zone 2 and you can't bi wire or bridge the main room either.
 

·
Premium Member
Joined
·
47 Posts
Discussion Starter · #3 ·
I'm running a 7.1, I know the rears will not work while in zone 2, and you have to de-activate the rears or something like that. What I'm trying to do is run my outdoor speakers from power zone 2


Connecting Your Zone 2 Speakers Directly

to the AV receiver

This setup allows 5.1-channel playback in your main

room and 2-channel stereo playback in Zone 2, with a

different source in each room. This is called Powered

Zone 2, as the Zone 2 speakers are powered by the AV

receiver. Note that when Powered Zone 2 is turned off,

you can enjoy 7.1-channel playback in your main room.

Notes:

• When “Act” is selected and Zone 2 turned on, the

Zone 2 speakers connected to the ZONE 2 L/R

speaker terminals output sound, but the surround back

speakers connected to the SURR BACK L/R speaker

terminals do not. When “Act” is selected and Zone 2

turned off, the surround back speakers output sound as

normal.

• Powered Zone 2 cannot be used if “Speaker Type:

Front(Speaker A)” is set to “Bi-Amp” or “BTL”, or

“Speaker Type: Front(Speaker B)” is set to “Normal

Speaker impedance

Speaker Type

Front(Speaker A)

Front(Speaker B)

6ohms

Normal

Not Use


I have done all of the above things more than once and once I go into speaker settings, I do not have the option of front speaker A & B, it just shows Front. Somebody help me please.

Catbird
 
1 - 3 of 3 Posts
Top