AVS Forum banner

1 - 20 of 2870 Posts

·
Registered
Joined
·
29 Posts
Discussion Starter #1
Onkyo USA Support Information


08/19/2014 Loss of Audio/Network Connection Customer Care Program


As part of our commitment to quality and customer service we have determined that a limited number of Onkyo Brand receivers manufactured between 2009 and 2012 may experience loss of audio or loss of network connection. This malfunction has been traced back to a defective network chip.
We deeply regret any frustration or inconvenience this situation may have caused.
To address the problem and help people who may have an impacted receiver, Onkyo is launching a special Customer Care Program to remedy this issue for those receivers that may be affected by this loss of audio/network connection issue. This program has three steps:
1. Verify if your Onkyo receiver is impacted
2. Decide how you prefer to address the issue
3. Send us your receiver in a prepaid box and label that we will provide at no cost to you
As part of this program we are also extending our standard limited warranty period to cover this issue for affected receivers through December 31, 2018. All other terms, conditions and limitations of the original limited warranty shall continue to apply for the duration of the original standard limited warranty.
Importantly, please note that the loss of audio/network connection issue will not result in harm to any connected components or speakers since the issue is contained to a single element within the affected receivers.
To determine if your receiver is eligible under this Customer Care Program please click here
Loss of Audio/Network Connection Customer Care Program for US and Canada customers
We thank you for your loyalty!
Onkyo again apologizes for any inconvenience this may cause and will provide this repair as expeditiously as possible.

This is great news for all Onkyo owners with failed HDMI/No Sound issues.
 

·
Registered
Joined
·
4,492 Posts
This will be interesting to see how this plays out. They say it is caused by a single element (defective network chip), however, most people with HDMI issues are finding it is cap related and doesn't have anything to do with the network chip.

I hope they cover the HDMI boards for everyone that has issues, but I have a feeling the fine print is going to prevent most failures from being covered. This is one time that I would like to be wrong.

I give them props for taking responsibility, but it should have happened long ago.

It's also interesting how there isn't a list of receivers with the problem, you have to go to their site and enter your serial number to see if it is covered.
 

·
Registered
Joined
·
4,466 Posts
Well, i just entered the s/n of my TX-NR905 which has no audio... I get an error, invalid serial number....
 

·
Registered
Joined
·
3 Posts
Well, i just entered the s/n of my TX-NR905 which has no audio... I get an error, invalid serial number....
about 3 months ago I took my tx-nr3007 in for a one time courtesy repair that Onkyo approved for the hdmi no audio issue, got it back with a replaced hdmi board but now my left surround channel is out. No sound at all. I never had that issue before and I'm pretty sure that when they opened it up something went wrong.... Now i have to see if the service center will repair it at no extra cost since that occurred after they worked on it or if i have to pay out of pocket. Just annoyed because a Pioneer Elite unit I've had for 2 years longer hasnt had a single issue and this 3007 that I really enjoyed keeps having problems...
 
  • Like
Reactions: Rbjack

·
Registered
Joined
·
1,232 Posts
It looks like good news. I have the 3009...........and if the Audio goes out it looks like that is covered.........it says the coverage is for loss of audio.........we all know why and what this usually is from..........saying it is just a bad chip makes it sound better than "Our HDMI Boards all will fail"...........that sounds more severe and damaging to their reputation then saying "a bad chip".


If mine goes........I will use the Onkyo coverage instead of my Vision's coverage.........and get my $150 back as a credit to use at Vision's assuming I don't have to claim for another type of "non Onkyo covered repair". This is welcome news for me.


It looks good for Onkyo if they are standing behind their product........but it would be better if they would do the following:


Fix the issue on newly released units.......design or manufacturing issues......whatever......fix it.
Add back XT32 (or a better newer version if there is one next year). Decide to go back to making 3010/5010 grade units..........with the lighted remote like the 09's. The new 3030 has downgraded amps (and weight too).
 

·
Registered
Joined
·
999 Posts
Doesn't the fact that all Onkyo receivers run hot, contribute to the failed HDMI board issues?

Seems to me, that they should concentrate there efforts on finding a way to make cooler operating receivers.
 

·
Registered
Joined
·
144 Posts
Doesn't the fact that all Onkyo receivers run hot, contribute to the failed HDMI board issues?

Seems to me, that they should concentrate there efforts on finding a way to make cooler operating receivers.
I read on another thread this has been resolved. New models run from 105-109 (from memory).
 

·
Registered
Joined
·
86 Posts
A day late and a dollar short for me. They have known about the HDMI issue for years and are just now dealing with it. My (Integra 70.2) is on it's second HDMI Failure in two years. The first was repaired under warranty. It has failed again and my dealer is replacing the whole unit with another one through an exchange program that Integra (Onkyo) has with it's dealers. When I get the replacement, I will sell it as I have no faith that it will not fail again. I just purchased a Yamaha RX-A 3040 and will not look back. Onkyo has tarnished it's reputation with repeated failures and repairing with parts that will fail again. It will be quite some time before I trust them again.
 

·
Banned
Joined
·
1,191 Posts
It looks like good news. I have the 3009...........and if the Audio goes out it looks like that is covered.........it says the coverage is for loss of audio.........we all know why and what this usually is from..........saying it is just a bad chip makes it sound better than "Our HDMI Boards all will fail"...........that sounds more severe and damaging to their reputation then saying "a bad chip".


If mine goes........I will use the Onkyo coverage instead of my Vision's coverage.........and get my $150 back as a credit to use at Vision's assuming I don't have to claim for another type of "non Onkyo covered repair". This is welcome news for me.


It looks good for Onkyo if they are standing behind there product........but it would be better if they would do the following:


Fix the issue on newly released units.......design or manufacturing issues......whatever......fix it.
Add back XT32 (or a better newer version if there is one next year). Decide to go back to making 3010/5010 grade units..........with the lighted remote like the 09's. The new 3030 has downgraded amps (and weight too).
My 876 is almost 6 years old now. I've read of higher end units like this one failing and I can't help but wonder how many Onkyo owners read about the heat failures on line but shrugged their shoulders at spending $25 to buy a widely available small fan and power source. Maybe they thought that Onkyo shouldn't make faulty units and they shouldn't have to buy a fan, so didn't. I thought, I'll spend 25 in insurance and 6 years later my receiver has been flawless. I'd rather spend for the fan than have a failure or 2 to deal with.

I also wonder how many ignored the instructions in the manual and crammed their Onkyo into tight enclosed shelving(and of course wouldn't admit that to Onkyo)thus ensuring they would cook the hdmi board. It's a mess, I know. Onkyo apparently got the daughter board in question from Toshiba and somehow the spec for the capacitors that fail should have been 105 degrees instead of 85 degrees. At some point they no doubt realized they screwed up, and didn't do much about it. For that their rep has suffered greatly and rightly so. I just look at my flawless 876 and wonder how many could have avoided all the trouble they had by listening to what they read on forums like this. Even now owners are probably reading this and shrugging their shoulders instead of doing something before the trouble strikes.
 

·
Registered
Joined
·
5,522 Posts
It doesn't sound like this is addressing HDMI board issues. What does the HDMI board have to do with networking? Why would the problem be audio only?


I think this addresses another defect.
 

·
Registered
Joined
·
4,466 Posts
It doesn't sound like this is addressing HDMI board issues. What does the HDMI board have to do with networking? Why would the problem be audio only?


I think this addresses another defect.
Another reason to quit Onkyo...

On a sidenote, the TX-NR905 is not covered... Even though it is suffering the same issue, no audio....
 

·
Registered
Joined
·
144 Posts
It doesn't sound like this is addressing HDMI board issues. What does the HDMI board have to do with networking? Why would the problem be audio only?


I think this addresses another defect.
It is the same issue. From first hand experience, when the hdmi audio goes out, so does the networking. I do not know the relationship or which is the cause vs symptom, but it is an accurate reflection of the problem.

I contacted Onkyo back in April, before the announcement mentioned and they fixed it. This is my first Onkyo product and probably my last because I will be likely go w/ separates next purchase, but from the time I've dealt with them, they have handled this the way I would have hoped.
 

·
Banned
Joined
·
1,191 Posts
It doesn't sound like this is addressing HDMI board issues. What does the HDMI board have to do with networking? Why would the problem be audio only?


I think this addresses another defect.
I am assuming that "network connection" is referring to the HDMI board. I could be wrong though.
 

·
Registered
Joined
·
493 Posts
Makes me wonder if my old NR807 would be covered now... After I was getting nowhere with Onkyo in my claim that was just out of warranty, I sold the receiver for parts at a huge loss. Seeing this only burns more considering they didn't want to accept my warranty claim back then. The issue, no sound... lived in an open air completely ventilated shelf with more than enough space to breathe. I have since swore off Onkyo, but will be interesting to see if they fix all of their issues, but I'm going to need to see at least 3 years of quality products to gain any trust back again, and even at that, may avoid out of principal.
 
  • Like
Reactions: Onk Yo

·
Registered
Joined
·
18,923 Posts
I would not buy Onkyo having been a regular here for a long time and having read so many complaints. But even Yamaha fails, I have a dead RX-A8xx here that won't stay turned on, and that thing wasn't too old when it failed.
 
  • Like
Reactions: OnkyoUSA

·
Banned
Joined
·
16,231 Posts
Hmmm....after a few years of use I have just in last few days had an audio dropout here and there and my Onkyo android app has been funky......but hadn't yet suspected the avr at this point but rather my sources (I have not the best internet situation where I live with CenturyLink DSL modem/router, and for all I know DirecTv issues even though a change of channels found audio returning right away and who knows with android apps, new to that but wouldn't be the first one to have issues) but if turns out to be avr glad to see I have an avenue like this. Thanks for posting.
 

·
Registered
Joined
·
1,789 Posts
After entering my model # (TX-NR609B) and serial # they say that mine doesn't need the repair. I'm actually not having any problem, knock on wood, but checked off that I was to see if mine would be covered. I'm HOPING that because mine was a refurb purchased directly from Onkyo a little over a year ago MAYBE it had an updated HDMI board or "network chip".
Hey, one can hope........


Ed
 

·
Registered
Joined
·
4,492 Posts
Onkyo apparently got the daughter board in question from Toshiba and somehow the spec for the capacitors that fail should have been 105 degrees instead of 85 degrees. At some point they no doubt realized they screwed up, and didn't do much about it. For that their rep has suffered greatly and rightly so.

The really stupid thing is not fixing the issue once it was brought to their attention and on top of that, they never implemented a change, because people have had their HDMI board replaced under warranty and then had the replacement fail as well! From what I have seen and heard so far, this isn't going to address the HDMI board issue that most people are having.
 

·
Registered
Joined
·
448 Posts
This will be interesting to see how this plays out. They say it is caused by a single element (defective network chip), however, most people with HDMI issues are finding it is cap related and doesn't have anything to do with the network chip.
Not necessarily, at least for the years mentioned in the warranty extension. My integra DHC 40.1 had issues that were identified as the DSP chip on the HDMI board. It was fixed by Onkyo/Integra after much hassling. It is the same issue that happens to the 40.2 and 40.3 as well as the 80.1-80.3. I don't know the Onkyo side as well, but one can see it is older Onkyo products that generally had the cap issues.

I wonder if this includes Integra Home Theater. I hope so.
 
1 - 20 of 2870 Posts
Top