[Wintrmte]

All,


I just purchased the Onkyo TX-SR607 receiver and have a pair of Klipsch Synergy F2 floor speakers. I'm looking at the back of the speakers and there's an A and B positive/negative posts (these are the speakers for the Front Left, Front Right)


On the back of the Onkyo, I don't see where there would be an A speaker or B speaker posts (like my Yamaha had), just the Front Left, Front Right posts.


Anyone have any advice as to which connectors on the klipsch go into the Onkyo?

 

[hkk]

I think the F2s have bi-amp capability, which is why there are 2 sets of connectors. With the Onkyo 607, you could setup them either as normal or bi-amp'ed. When using in normal setup, you leave the jumper on between the 2 sets of connections (on the speakers), so essentially both connectors get the same input. When bi-amp'ing, I think you use the zone 2 connections on the Onkyo.

Give a quick read of Onkyo manual. It has all the details.