AVS Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter · #1 ·
Hello All,


I finally got a Powered sub (Polk PSW111) to connect to my Onkyo TX-SR703 though I get no sound on "subwoofer out" jack.


The powered subwoofer is being connected first time to this unit and I believe it is OK - strong bass hum when touching tip of plug. But no sound on every input and listening mode.


Reciever Settings:

loudspeakers: left, center, right, and powered subwoofer. No side surround or back surround (not yet at least), but Zone2 connected.


Speaker setup:

Subwoofer: yes

Front: full band

Center: 80hz (THX)

Surround: 80hz (THX)

Surround back: No

LPF or LFE: 120 Hz

Subwoofer mode: D. Bass

Subwoofer level: 0 db


Not sure if it is dead from the beginning, don't know, because this is the first time I have used a subwoofer. Maybe it is error in settings or failed part? I have heard of this being an issue on the TX-SR803 as well.


I currently have the sub connected to the Front Left and the Front Right PRe-outs to the Left and Right LINE IN on the SUB. It works.. but I know I am not going to be able to fully enjoy the sub since certain signals are only sent directly to the sub...


Thanks in Advance!
 

·
Registered
Joined
·
12 Posts
Discussion Starter · #2 ·
Ok, So no replies on this one?? Hmm...
 
1 - 2 of 2 Posts
Top