AVS Forum banner
1 - 14 of 14 Posts

· Registered
Joined
·
688 Posts
Discussion Starter · #1 ·
I was under the impression that I would be able to use my Onkyo TX-SR706 receiver in the following way:


Connect a piece of equipment (in this case, Nintendo Wii) to either a composite or component input (in this case, component) and send the video to my display via the HDMI output.


I think I have everything hooked up correctly, but it's definitely not sending the video. Audio is working fine.


Any thoughts?
 

· Registered
Joined
·
688 Posts
Discussion Starter · #3 ·
Yes, I did.


My HTPC is plugged into "IN (1 DVD)" via HDMI.

DVD is assigned HDMI 1.


My Wii is plugged into "IN 2 (CBL/SAT)" via component.

CBL/SAT is assigned Component Video IN2.


HDMI output resolution is set to 1080p, so the receiver should be upconverting and outputing all video through the HDMI output to my display, correct?
 

· Registered
Joined
·
688 Posts
Discussion Starter · #8 ·
Right, makes sense now. I changed the default HDMI3 for CBL/SAT to ----


I searched the official TX-SR706 thread for "Wii" as it seems there are quite a few people with issues, but all of those people are at least getting the video to pass to the display first! I can't seem to get that much.
 
1 - 14 of 14 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top