AVS Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
245 Posts
Discussion Starter · #1 ·
Obviously this has to be engaged to power the projector (the little switch that turns on when you close the lamp door).


But does it have any other purpose?


I'd like to get on the PCB and solder it closed all the time -- I see 2 pins marked TH SW ? Anyone know where it is on the PCB.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top