AVS Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
6,207 Posts
Discussion Starter #1
I bought a house that used satellite, and thus had two coax runs in the house - one for the antenna, one for the sat. I'm using the "antenna" run to route the ReplayTV signals, and the "sat" coax run is unused.


Currently, I'm using X10 Powermids to control IR. Works very well, but not absolutely perfect.


Are there any wired IR solutions that can utilize my existing coax run?
 

·
Registered
Joined
·
188 Posts
Hi Randy. Not sure if it fits in with your other stuff but check ou the thread I posted today about dist./ctl of N replays - I am using existing coax runs for IR and modulated signal distribution.

http://www.avsforum.com/avs-vb/showt...threadid=90784


The avcast link I put in there has discounted prices - u may not need the media caster stuff but you could maybe use the cable caster as an IR engine and simply put IR casters where u need them to detect and send IR over the coax runs...


it worked beautifully in minutes for me.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top