AVS Forum banner
Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter · #1 ·
Hi,


I purchased a 65H80 in may and 1:85 material has the same size "black bars" as 2:35 material. The 1:78 material does fill the screen correctly. Is this an Overscan problem? Can I correct this problem in the Service mode?


Also when the "Black bars" are visable there is a very slight inward "bowing" at the corners. I take it that this is what is considered a Geometry Problem?


Would ISF calibration correct these issues or should I attempt to have Toshiba send thier local servicer.


Thanks for any input you have,

Ariel


P.S. Anyone have a contact of a good ISF Tech in Atlanta?


Thanks Again




------------------

MY DVD COLLECTION:
 

·
Registered
Joined
·
36 Posts
i also own a 65h80 and live in the atl, area, i relized the problem within the first couple of days i purchaed it, they sent someone out and they fixed the geometry problem, it doesnt appear to bow anymore, but u can see a little bowtie effect on the edges, but not on 1:85.1 material
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top