AVS Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hi everybody,

I just got this set last weekend and it's excellent! I seem to have recieved a good one because there is almost no geometry problems with it except for a slight 1/16 of an inch bow at the bottom. It's not that noticable at all unless you look for it. Well the point of my post is how to adjust convergence on this set. The convergence is slightly off on the upper left corner and the lower right corner. I hope there is a way to fix it since I don't want to risk getting a set with bad geometry if I return this one. Any help would be appreciated. Thanks.


PS can anyone post the factory settings for the service mode for the TV also? I've seem to have misplaced the sheet I've wrote them down on. Thanks.

 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top