AVS Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
1,055 Posts
Discussion Starter · #1 ·
After viewing a channel that outputs 480i in Just mode, if I switch to a channel that outputs 1080i, I understand that the panny would automatically switch to Full mode.


My question is, does the panny automatically switch back to Just mode when I switch back to a 480i output channel? Or does the Panny stay in Full mode?


In other words, the sequence goes like this:


480i channel (Just mode set manually) -->

1080i channel (Full mode set automatically) -- >

480i channel (Stay in Full or go back to Just?)


TIA.
 

·
Registered
Joined
·
113 Posts
When you switch back to a 480i or 480p channel from a 1080i channel, it will go back to whatever wide mode you were last using for a 480i/480p channel. So, if you're watching in just mode, and you tune to 1080i channel in full mode and then switch back, the channel will come back in just mode.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top