AVS Forum banner

Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter · #1 ·
I purchased AE100 projector for just a few days. I use Focus quadscan elite for the projector with the output of XGA. Last night the lamp of the projector suddendly turned off itshelf while I was watching. I tried to turn on the projector a few times. The lamp was still turned off after a minute.


Is there any conflict to use the Quandscan in AE100 or it is only the problem of the porjector itshelf and not related to use line doubler Quanscan.


Thank you very much!
 

·
Registered
Joined
·
87 Posts
I am sorry to tell you that you need to take back to your dealer to exchange for a new lamp. The same problem happenes to me with my new panny for about 20 hours usage.
 

·
Registered
Joined
·
10 Posts
Was there any flickering prior to the lamp dying? Several of us have seen similar conditions. My AE100 is currently en route to Japan for exchange. A very sad thing....


btw - Are you running the lamp mode in Low or High? Seems that all failures so far have been in Low. Could be coincidence, but anythings possible....
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top