AVS Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
42 Posts
Discussion Starter · #1 ·
I read a post regarding the ecp 4500 blue tube not lighting and wondered if the advice would transfer to the pg6. I am obviously new at this and have found this forum extremely helpful and would value any help. the blue tube lights with all test pattern except for horizontal lines when the red and green tubes are off. During video either s-video or rgb the blue is very dark compared to the red and green and g2 adjustments have little effect. I have stopped making g2 pot adjustments until I can fix this problem. Another post on the ecp4500 suggests switching the board on the end of the tube between the red and blue to see if this will diagnose the bad board. Will this work for the pg6000 as well and if so are the replacement boards readily available. Any help or guidance would be appreciated. Is there a way to donate to this forum using paypal. The information here is second to none.



thank you


carlton
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top