Quote:
I'm using the 1014, so it should be similar.
1. Set the crossover in the A1.
2. Set speaker distance in the A1, I just copied over the ones used by the receiver from the auto MCACC
For sub, I had to adjust sub channel to +10 on the 1014 and 0 on the player (with other channels in the -6 range on the player).
| Originally Posted by caser85 All, I was reading the manual on my Pioneer 1015TX receiver tonight and realized that it says very little about analog inputs. This is causing problems in that I don't know the following: 1. Do I need to set up crossover in HD-A1, or does my crossover that was set up during MCACC on the receiver work? 2. Do the speaker distances work while in analog input mode or do I need to set these on the HD-A1? 3. I know I can adjust my levels, so I'm good on that. 4. If I adjust my sub based on Avia, will it be good for HD-DVDs? Reason I asked is that I used Avia to adjust everything and it seemed fine. Then I played U-571 and the bass was lacking. Do I just need to crank up the bass some more? Thanks, Casey |
1. Set the crossover in the A1.
2. Set speaker distance in the A1, I just copied over the ones used by the receiver from the auto MCACC
For sub, I had to adjust sub channel to +10 on the 1014 and 0 on the player (with other channels in the -6 range on the player).
