AVS Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hello all,


During a move, I broke off one of the rear surround sound speaker binding posts.


I was thinking about replacing it, but I wondered if it is soldered directly to a board or by a connecting wire.


I figured I can replace the binding posts if its attached with a connecting wire or just solder a speaker wire to the end of the broken off binding post still sticking out a little bit.


Loooking for the easier fix.


Thanks,

Jason
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top