AVS Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
182 Posts
Discussion Starter · #1 ·
Hello Everyone,


I have somewhat troubling problem that that I don't know what to do about.


During the 72 point convergence (in all modes) there is a bend in the far right vertical convergence line that is on the bottom about 1 inch long and bends toward the center of the screen.


The last convergence point + does convergence with the bend pretty well.


What could cause this bend (all other lines are fine) and should I send the set back since it is well within the 30 days. All else is fine


Thanks for any help


Al
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top