Joined
·
21,783 Posts
I want to program some remote control macros for Pro1000 on/off commands- would prefer IR discrete commands but as far as I know, it it just a toggle so I need some way to determine its state
so my alternative is a sync sensor (but I see no output for input 2), a voltage sensor (low voltage) or RS-232 (through the connector that Pioneer says not to use- I think it is used all the time): this is for RTI T2 remote
Question- what do you suggest/use for this?
Mark
so my alternative is a sync sensor (but I see no output for input 2), a voltage sensor (low voltage) or RS-232 (through the connector that Pioneer says not to use- I think it is used all the time): this is for RTI T2 remote
Question- what do you suggest/use for this?
Mark