AVS Forum banner
1 - 3 of 3 Posts

·
Banned
Joined
·
9,076 Posts
Discussion Starter · #1 ·
My 7130 kept going into high speed fan mode so I sent it in. Projector returned with a messed up corner, but high speed fan mode seemed to be fine. Later high speed fan came back and I got a dust blob. Sent projector in again. Received it back and high speed fan mode was still a problem. Planar had me return it and they replaced with a different (7130) projector. This 7130 has image problems. People's faces in dark scenes look red and blotchy. Also has started up in high speed fan mode three times, but after about 45 minutes it drops down to low speed fan. I can't even get into many of the menu options, they are greyed out. With HDMI to DVI cable:

Picture, Fine Sync and Layout are greyed out.

Under Options Deinterlace and Sync Threshold greyed out. Here is a link to a picture of the blotchy red faces. http://i243.photobucket.com/albums/f...0/IMGP0057.jpg


Getting pretty frustrated with this projector. Anybody have any suggestions?
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top