AVS Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
103 Posts
Discussion Starter · #1 ·
Hi. I'll try getting an answer for this question again. I have made a RGBH to Scart-cable. Now I have to solder on the V-sync cables as well to get a composite sync-signal without enabling it with Powerstrip (my new graphics card wont do that.)

So. Where do I solder V-Sync? Should it be on the exact same pins as H-sync. Just merging them together, or what?

Could someone please tell me which pins on the scart to solder the V-Sync ground and V-sync to:


HD15(vga)------Scart---Name


1---------------15------Red

2---------------11------Green

3---------------7-------Blue

6---------------13------Red ground

7---------------9-------Green ground

8---------------5-------Blue ground

10--------------17------Sync ground (H-sync)

13--------------20------Composite sync (H-sync ground)
 

·
Registered
Joined
·
103 Posts
Discussion Starter · #2 ·
Ok. I've read around in other posts and was today convinced that I should solder the V-sync on the H-sync and The V-Sync ground on the H-sync ground, so I did this. This, however still didnt help. I have to enable composite sync in Powerstrip to get a picture. Same as before. Whats wrong? IOA did this before and it should work without composite sync in Powerstrip on his Geforce 2?!

I'd reeeeally like to know :p
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top