AVS Forum banner
1 - 9 of 9 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
I have a 5.1 setup. The bonus room is quite large, with appx dimensions of 28 x 16. I plan to mount 5 in wall Polk Audio RC65i or Polk Audio RC85i. The decision is which I should choose. The speakers will be driven by a Yamaha RX-V473. I will also use a Polk Audio PSW505 powered sub.


Will the RC65i be loud enough? Or will they be drowned out by the PSW505 sub?


THanks for any feedback.
 

·
Registered
Joined
·
7,063 Posts
I would definitely go with the RC85i, because its larger size will give you a greater volume of sound without distorting. You will need that in that large room.


The subwoofer has a volume control on it, so there is no reason for it to "drown out" anything. If it is too loud relative to the other speakers, you just turn it down.....


Actually, I question whether the PSW505 is powerful enough for that room.


You might need either two of them, or a more powerful sub (such as the Klipsch RW12D). If you already have one, it is easy enough to buy another one if needed.

 

·
Registered
Joined
·
8 Posts
Discussion Starter · #6 ·

·
Registered
Joined
·
4,512 Posts

Quote:
Originally Posted by heatwavex  /t/1454396/polk-audio-rc65i-vs-rc85i#post_22885272


Or what about these BIC speakers? They are the 3 way variety.


Product Features

Three-way in wall speaker system

1-inch titanium dome tweeter, 2,5-inch poly midrange, and an 8-inch poly/graphite woofer

10-175 watts per channel, 375 watts dynamic peak

Magnetically shielded

7 year warranty for parts and labor

http://www.amazon.com/BIC-America-HT8W-Acoustech-Speakers/dp/B000B7NAP4/ref=cm_cr_pr_product_top

That is one of the strangest speaker designs I have ever seen, so I would avoid it... The horn loaded Bics are the only Bic speakers I would bother with.
 

·
Registered
Joined
·
1 Posts

What about the following room config:

 

14'x10' (open floor plan which opens to kitchen, etc)

Yamaha RX-A1010

 

I was considering these speakers, but wanted to know what I should use for front / rear channels.

 

Thanks

Ben
 

·
Registered
Joined
·
152 Posts
1 - 9 of 9 Posts
Top