AVS Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
24 Posts
Discussion Starter · #1 ·
Would the Polk RC65i in walls be a good choice for RS and LS surround speakers as part of a 7.1 system?


I have not decided yet on the LCR setup but I hope to get a timbre matched set from the same brand/family. Does anyone have any experience with these Polk speakers? My understanding is that the surrounds are not as important to match as the LCR speakers. What are your thoughts on these or any other brands in a similar price range. Here's my setup:


Basement home theater/TV room with fairly good acoustic properties

Denon 2312ci

Yamaha 10" powered sub (will be upgrading to better 12" BIC or HTS soon)

Sonance LB and RB speakers in ceiling behind couch

LCR setup to be determined but will likely go with high quality in wall speakers for LF and RF. currently have some old but good Inifinity speakers there in the meantime

Right and Left surrounds will be mounted in wall on each side of the main viewing area just above ear level about 6' away on each side


Thanks for any help in advance.


av_freek
 

·
Registered
Joined
·
6,506 Posts
I use 4 of these with a sub along with the Denon 2312 in my open main living room and it exceeds my expectation. I mean i did not expect them to sound this good. I was able to go on top of the attic and nail some plywoods on studs around these speakers, add some insulation around them to enclose them in boxes and the result is better bass respond. I highly recommend you doing so if possible. Auddesey drops them 20hz lower after nailing plywood around them than without.
 

·
Registered
Joined
·
24 Posts
Discussion Starter · #3 ·
thanks for the tip. where im putting them there are actually vertical studs and strangely enough horizontal studs about every 24 inches so I already have a perfect frame there that I could put some plywood or mdf on to make a little box like you did. did you put any filler or insulation in the box with the speakers? if so what did you use?
 

·
Registered
Joined
·
6,506 Posts
I use the rectangular piece of insulation that usually go between wall stud. You do not want to use filler (the blow-in kind going in the attic)
 

·
Registered
Joined
·
2,818 Posts
I think you'll be pleased with the Polk in-walls. I had these in my bedroom and family room originally for whole-house audio, but after hearing how good they sounded, I got a few more and built out a 5.1 system. Had a stand-alone sub for the family room and the in-wall sub for the bedroom. Both rooms sounded pretty darn good!
 
1 - 7 of 7 Posts
Top