[zenshikai]

Shoot [email protected][email protected]# I just finished imaging my HS2000 and was working great (after being stored a year and a half) and now the unit will not turn on.


I took out the power supply to see if anything is burnt and I am about to test the leads for voltage with my volt meter, but I don't think I can fix it.


Are there any troubleshooting guides for power supplies or as a last resort where can I purchase one?


TIA.


Very Bummed

zenshikai

 

[sfhub]

Mikeyboy to the rescue...

 

[Mikeyboy]

You may have blown the fuse on the power supply. It is soldered on and can be replaced. To check the voltages there are two pics posted right below this post. http://www.avsforum.com/avs-vb/showt...58#post2096458

 

[zenshikai]

Both readings for the voltages were 0.


Mikeyboy, I opt for the fuse (according caution label on the hard drive cover is a 3.15A, 250V) hopefully I can find it at radioshack, otherwise let me know how much for a power supply if you have one.


zen

 

[zenshikai]

I read your reply to another powersupply problem, I will try to get the pigtail fuse at radioshack.


Thanks.


zen

 

[JJON2121]

If you can get your hands on an AT power supply, you can test your replay to verify the problem is the power supply.


I did replace one of my 3ks with $10 AT power supply. If you use a regular sized one, you will have to remove the cover and trim it up a bit.


The thread below will tell you everything:


Dead Showstopper 2000
http://www.avsforum.com/avs-vb/showt...hreadid=145583