AVS Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
197 Posts
Discussion Starter #1
(I know 47.952)


I've read Karnis and other's guides, but wanted to see about some crt specific answers.


I'm trying to arrive at 1280x720 @ 48hz. I am currently running 1280x720 @ 60hz into an ampro 2000g


in powerstrip the horizontal scan rate & the refresh rate and linked to one another. I was trying to get the resolution set up on a computer monitor 1st, my monitor will not let me get down to 48hz...as I get to ~ 51 it goes black.


When hooked up to the pj I can go from 60hz and type in 47.952, but the convergence goes to hell. Colors shift by 2" on a 85" screen. (and my electronic convergence controls are pretty neutral...ie. physical setup was pretty good)


Is that normal? to have to go through a whole new physical & electronic convergence setup when going down in frequency or am I doing something wrong w/ powestrip.
 

·
Registered
Joined
·
299 Posts
You will have to create a channel or recall memory for the different setting. The same thing happened with my projector.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top