AVS Forum banner

Status
Not open for further replies.
1 - 8 of 8 Posts

·
Registered
Joined
·
1,033 Posts
Discussion Starter · #1 ·
I am building a new house but cannot affor the Elan Via Panel just yet. I would like to pre-wire a couple of locations - so the question is, what should I run to each location? I assume RG6, Cat5 and what else?


Thanks

Matt
 

·
Registered
Joined
·
1,265 Posts

·
Registered
Joined
·
1,265 Posts
Quote:
Originally posted by Video
Does it need power too? If so, what type of wire should I run for that?


Thanks
damn good question! If it wasn't for you I would have not known that.



Their website is down. I saw it earlier. I think you need 18/2 CL3. When they are back up I will point you in the right direction.
 

·
Registered
Joined
·
1,033 Posts
Discussion Starter · #5 ·
But I saw no mention of power. I will call some local dealers to find out. I inherited some Elan Z gear and would like to get it installed. Problem is, the local dealers in Omaha want to sell you the whole thing turn key and are not too motivated to return my calls. I wish I could find someone that does both Elan integration and ISF calibration.
 

·
Registered
Joined
·
1,265 Posts
when ever the web site is back up go to the via page and you have to click another link on the right side and it gives you the power specs.
 

·
Registered
Joined
·
1,265 Posts

·
Registered
Joined
·
1,033 Posts
Discussion Starter · #8 ·
Thanks, just what I was looking for.


Now to run wire (WIRES) Spent about $3k already (yikes)
 
1 - 8 of 8 Posts
Status
Not open for further replies.
Top