AVS Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
748 Posts
Discussion Starter · #1 ·
Hi I took the top casing of my Prismasonic FE1500R to clean it as had some marks on it. after cleaning inside I put it all back together and installed it in front of my lens, but now the remote doesn't work when pressing the buttons.


Any ideas on how to fix this some how ?
 

·
Premium Member
Joined
·
16,979 Posts
I am betting the remote is fine. Ck to make sure the IR receiver did not come up plugged.

I am not in front of my to see if it has a plug or not.

Next, ck the gears to make sure they are not binding keeping the motor from moving the lens. If not put together perfectly this could be the case. Loosen everything and will not fully tight give the remote a try if everything works then tighten everything down again being careful to not shift anything. Let us know how you make out.
 
1 - 4 of 4 Posts
Top