AVS Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
I simply can´t get the projector to show 1024 x 768 via DVI connection.

It´s no problem to get the resolution via VGA connection.

With DVI the projector can´t recognize the signal at that resolution at any refresh rate.

If I use PowerStrip I get a picture, but it´s screwed up.


I have a Geforce3 graphic card connected to an Infocus LS110 (firmware 3.6) via Infocus own special DVI-cable (M1-DA 10.0 metres).

I have Windows XP SP1.


I hope someone could help me.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Status
Not open for further replies.
Top