AVS Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
309 Posts
Discussion Starter · #1 ·
I've done some searching for tehe past few days and have been unable to find any help regarding my issue.


The issue I'm having is that my Harmony 880 remote lags when it sends commands to the box. I push the buttons on the remote, and then a few seconds later the numbers pop up on the screen. This gets annoying when fast forwarding through a recorded show or such.


I'm sure that the problem lies in the ir delay settings in the Harmony software, and I was wondering what settings you guys out there are using, and if anyone else is having the same problem.


Any help would be appreciated,


Thanks.
 

·
Registered
Joined
·
692 Posts
I would call Harmony (Logitech) and explain the problem to them - they generally have very good technical support and I doubt this would be an unusual question for them.


Ross
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top