AVS Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter · #1 ·
I have been loving my Dwin with DVD's. I recently upgraded from a Dreamvision DL500 with a DVDO. The improvementis remarkable. However...I bought a Dish 6000 so that I could get the HD HBO and Showtime channels. After installation, the picture was beautiful until it had been running for 45 minutes or so. Then what I'll call alias lines began to appear at the bottom of the screen, rolling to the top. First 1, then 3, then 10, etc., until it was not watchable. The input was hooked in to component 2. I added an additional (not Dish) HD input into component 3.

Both pictures are the same. I also tried it through the RGB input with similar results. If I stop the signal to the Transcanner, and then re-intorduce it, it starts out clean, but returns to the alias lines within a few minutes.

I am running DVD (480P) through the component inputs and it is fine. It seems to struggle with 1080i. Has anyone else seen this problem? Any ideas?





------------------

 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top