AVS Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
202 Posts
Discussion Starter · #1 ·
I have a nice AVP-S freshly redone by Harmon and use with with a PMDT and AMP5 for 2 channel audio. I had it setup using the 12v triggers but decide to switch to the PHAST plugs by using Cat5 cables. I cannot seem to get any COM functions with the PHAST whereas the 12v triggers had been working fine. Is there any trick to this? The AVP has an In/Out phast jacks whereas the PMDT and AMP 5 just have 2 unlabeled phast jacks. I tried every single combo of jack connections but the system never switches to standby from the AVP signal as it did before.


Thanks
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top