AVS Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
1,038 Posts
Discussion Starter · #1 ·
We got a new tv today & had to reprogram the RC64 remote to work with the new set. Problem we're runnin into is programming the remote to individually control a HD DVR & a HD receiver. We were able to do so when we had our other tv but now when the remote is in directv mode, it controls both receivers instead of 1. I tried programming a 2nd receiver on AV1 but it does the same thing which is control both receivers. Im wondering if I have to unplug 1 of the receivers to program the remote so it doesn't see both receivers.
 

·
Registered
Joined
·
1,892 Posts
Do not reset anything, one of your receivers will be left set to the default codeset 00001. Right now you have two receivers set to this same codeset, switching one to an alternate codeset from 00002-00008, then the receivers will no longer respond to the same device. Cover or unplug the receiver you're leaving set to 00001, see this thread on how to switch the hd dvr to the alternate codeset:

http://www.dbstalk.com/showthread.php?t=154302
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top