[Zipakna]

Hi all,
I need a piece of advice.
I want to buy the Q10b Transducer but i found the amp for it a little too pricey.
Can you tell me if the inuke 1000DSP is enough to drive it well in direct mount?
Maybe if someone have test it and can give me a feedback, it would be awesome.
Thank you for your help.

 

[clausdk]

Hi all,
I need a piece of advice.
I want to buy the Q10b Transducer but i found the amp for it a little too pricey.
Can you tell me if the inuke 1000DSP is enough to drive it well in direct mount?
Maybe if someone have test it and can give me a feedback, it would be awesome.
Thank you for your help.

I'm running one Q10b off one ch on an inuke6000dsp and havent run out steam yet. I'm looking at another Inuke to power it as I was using that ch for my rear subs. I think the inuke 1000dsp bridged would be ok but I guess the limiting factor is the AMP in that case. I'm aiming for another inuke6000 myself and use the spare ch for an extra sub

 

[Zipakna]

thank you, that helps me.
Nobody tried with the nu1000dsp?

 

[kaiforce]

You can expect to get around 650 watts into 4 ohms in bridged mode. Some germans measured it and found the specs to be exaggerated by about 33% in most cases.

 

[Zipakna]

Oh it's decrease a lot!
One last question :
How can i wire the q10B to the inuke? the input for inuke is xlr or jack but the q10b is a simple wire!

 

[Zipakna]

anyone?