AVS Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
42 Posts
Discussion Starter · #1 · (Edited)
I am building my first speaker ever, which means this is also the first time in my life I assembly a crossover for my speaker. It's for the Fusion 8 Alchemy. The layout looks similar to the photo on DIYSG website and based on the schematic provided by Erich.

I just dryfit all the components and would like to ask if it looks right? Is there anything I should pay attention to? I have not soldered anything yet, just in case.

In addition, should I connect the (+) and (-) inputs of HP and LP (midwoofer and waveguide) to a wire connect to the 2 binding posts of the speaker?

 

Attachments

1 - 1 of 1 Posts
Top