AVS Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
58 Posts
Discussion Starter #1
As usual I have tons of questions for you folks..


#1. Can the Denon AVR4802 pass a component signal from my RP5 via inputs to the LT150 via component "monitor"? I heard that some receivers, if not most don't have enough bandwidth to pass it.


#2. How can I watch cable with this projector? I heard some people say that the LT150 will display the video in a 4:3 aspect ratio but does it form the picture to fit inside my 16:9 screen or does the signal stay at a complete 4:3 with will need to be "squeezed" to fit in on the 16:9 screen?


#3. What's this about the DVDO Iscan V3? Would it make any difference running my RP56 through it via component or would is just improve my SVHS, DirecTV, etc. picture? And if so what's the basics on improving the picture? How does it work?



Thanks for any help
 

·
Registered
Joined
·
82 Posts
The 4802 has 50Mhz bandwidth which according to general consensus should be able to pass HDTV without visible degradation. There are those who claim that more than 50Mhz is necessary but most IMHO feel that 50Mhz in receivers is adequate.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top